The most common problems that are encountered with boilers are leaks, clogs, and boiler failure. This blog post will teach you the best way to Boiler Repair Colorado Springs.
Eventually, we all will need some Water Heater Repair Colorado Springs or boiler Repairs usually are not expensive if done by the proper method. The first thing that needs to be mentioned is this: If possible, try not to shut down your furnace entirely as this may turn out very costly. Generally, when trying to make repairs over the winter months, it is best to only turn the power off at night and back on during the day, thus allowing you time to make any necessary repairs before it is needed again in the evening. Doing so allows a particular safety factor including:
1. Once you have access to your boiler or water heater, be extremely careful when attempting repairs if it is a fossil-fuel-burning furnace (coal or oil).
2. Ensure that the unit has been bled of all fuel before beginning and not left in a hurrying state; once the power is restored, it will start up very quickly and with little warning. Never attempt any repair if you suspect that gas pressure may remain in the system.
3. If electric: If possible, try not to shut them down entirely as this may turn out very costly. Generally, when trying to make repairs over the winter months, it is best to only turn the power off at night and on during the day, thus allowing you time to make necessary repairs.
4. If you suspect that your boiler’s gas valve is faulty, there are a couple of simple ways to check this first:
- turn off the heating and power supply
- heat the water by turning on all of your hot-water taps.
If the pressure relief valve starts to release a steady stream of gas – your central gas control will need to be replaced.
Signs of a faulty control can be found by checking for “static” in the burners.
- Please turn on the main safety switch and press down lightly on each burner until you feel it start to fire, then let go.
- If they shut off immediately, there is no problem with your safety controls.
- If they hold more extended than usual or continue firing afterward – it’s time for new management.
To check for a faulty thermostat, click on the actuator wire to make sure it connects and releases; if not, the magnets are probably worn out, then replace it.
Gas Boiler Pressure Regulator
A gas boiler pressure regulator set to max or too high will cause your burners to continue firing at a high rate – which can increase your bills and be hazardous as well! To diagnose this, turn up the heat under your boiler gauge until normal pressure is indicated – then slowly turn down the heating control from complete towards minimum while checking the pressure gauge to see when it starts to drop. If it continues firing after you have turned off all of the heating controls, you will need a new safety control board, as explained above.
The final thing to check for on your system is the water level in both of your tanks. If one tank runs out of water, the other will also be deleted because it has stepped up to provide hot water while the first tank recharges.
As you can see, there are many reasons why you might get a no heat call, which all require different types of service. For this reason, you should make sure you know who did what work before signing any invoices or authorizing further work! This will help prevent any misunderstandings between yourself and technicians, along with helping make sure they don’t perform unnecessary repairs on your equipment!